2K Metal-Filled Epoxy Adhesive, Gray

• The surface to be repaired must be clean, dry and degreased. For better adhesion, roughen it with sandpaper.
• Take the syringe out of the pack and remove the plastic spatula between the plungers.
• Cut off the tip and use it afterwards as a cap.
• Expel the excess air. Squeeze out an equal amount of each component. The transparent part of the blister pack can be used as a mixing container. After use, draw the plunger back, remove the adhesive residue and close the syringe.
• Mix the compound thoroughly with the spatula to a uniform mass for 2–3 minutes.
• Apply the compound to the surfaces to be bonded and press them together lightly. Setting takes place 5 minutes after application. Full bond strength is reached after 24 hours.

At low temperatures the curing time increases. Use at temperatures above 100°C is not recommended. Not suitable for bonding polypropylene and polyethylene.

Important! If storage for more than 24 months or sharp temperature fluctuations have caused the compound to harden — heat the compound before use to +60°C. Heating radiators, hot water and so on may be used for this. Let the compound cool down a little and it will regain its original properties.

Attention! The compound must not be used for repairing kitchenware that comes into direct contact with food!